|
 Cardstock for stamped image layers, 11" x 4.25" cardstock for card base (here chocolate chip), rubber stamps, 1.25" circle punch, word window punch, dimensionals 
take your card base (11" x 4.25" card stock) and fold it in half, and punch a half circle a little to the right of the card. (not centered, but off to the right). 
punch two word windows over lapping a bit right under the 1/2 circle cut out. 
make your layers. You need 3 layers. One 4.75" x 3.75" (biggest cardfront layer), 3" x 4" middle slider, and 2.5" x 5" last slider layer. On the back layer, try to stamp your image and words as colose to the top as possible. Same with the middle layer. 
put the skinniest layer behind the word window and add two dimensionals in the slot. One about midway down and the other about at the bottom. 
attach your middle layer to the dimensionals. 
check to make sure the layers slide out smoothly and both layer images are able to be seen. 
add dimesionals to the front layer back side (as shown). Adhere to card being careful not to tape the middle layer down (so it freely slides).
add dimensionals to the card base inside...making sure to put one right under the last layer... so it can't slide down below that level. 
Finished card!  card when the payers are slid out
|
